Step 1: Film Installation

1. Clean the sunroof glass thoroughly and make sure the surface is completely dust-free. Please prepare your own cleaning solution.
2. Spray the cleaning solution evenly onto the glass surface.
3. Apply the ambient light film evenly onto the sunroof glass.
4. If the film size is slightly larger than the sunroof, carefully trim the excess edges to match the shape for a perfect fit.

Important Notes

• For 500ml–750ml water: Add 3 drops of dish soap (about the size of a soybean).
• For 2000ml water: Add 7 drops of dish soap (about the size of a soybean).
• Do not use too much dish soap, as excessive soap will prevent the film from sticking properly.

• When squeegeeing water, first squeegee in a cross pattern, then push water toward the four corners.
• Apply firm and even pressure, and wipe clean in one continuous motion.

• After installing the film, allow it to dry completely before proceeding.
• Do not install the light strips until the film is fully dry.
• If the film is not fully cured, removing the light strips later may cause the film to peel off and become damaged.